充電器是一臺設備的關鍵組成部分，充電方法的恰當是否會影響充電電池的使用壽命，因此恰當充電很關鍵，那麼今日人們就來跟您分享下：鉛酸蓄電池自動充電器的應用注意事項!

　　初次使用時請查閱電工值班記錄中用電單位白天、夜晚單項電壓記錄值中最高值，或實地測量確定最高電壓值，然后折去充電器外殼，將變壓器接線接到相應電壓值的接線柱上，再安裝上充電器外殼。

　　充電：將電池接線與充電器接線連接，必須分清極性，正極與正極連接，負極與負極連接，再將充電器電源插頭與電源連接，啟動充電開關開始充電，當蓄電池充滿電后，充電器將自動停止充電。

　　均衡充電：均衡充電是一項在加水型鉛酸電池充滿足了電以后，對電池進行過量充電的操作。當電池使用數個周期后，電池各單元電解液比重將失衡，應進行均衡充電，將電池與充電器連接，充電器電源插頭與電源連接，將充電器設置到均衡充電模式，開始充電，電池開始有氣體逸出產生大量氣泡后，每小時測量一次電解液比重，如果測量得到的比重不再升高，均衡充電即告完成。

　　充電器充后一組電池后，應間隔四個小時以上再進行下一次充電工作。